1. Before each program is processed, it is necessary to strictly confirm whether the tools are consistent with the program;
2. When installing the knife, you must confirm the length of the tool and whether the chip knife header is appropriate;
3. During the operation of the machine tool, the door is prohibited to avoid flying knives or flying.
4. If the operator of the knife is found during the processing process, the operator must be parked immediately, such as pressing the "Emergency Stop" button or the "reset button" button or adjusting the "feed rate" to zero;
5. Each time the knife is paid in the same workpiece, it is necessary to keep in the same area to ensure that the accuracy CNC processing center operation rules when the knife is connected to the knife;
6. If the CNC processing manufacturer finds that during the processing process, if there is too much processing, the "single section" or "suspension" must be used to manually remove the X, Y, and Z values after clearing it and then shake it back to the "zero point" Let it run by yourself;
7. The operator shall not leave the machine tool or check the operating status of the machine regularly during the self -operating operation.
8. Clean the aluminum residue in the machine tool before the light knife is injected to prevent aluminum residue from absorbing oil;
9. Try to blow with gas as much as possible in the rough program, and spray fuel in the light knife program;
10. After the workpiece is picked up, the burrs must be cleaned in time;
11. At get off work, the operator must handle accurate transfer to ensure that subsequent processing can be carried out normally;
12. Before shutting down, ensure that the knife library is in the original location, the XYZ shaft is parked in the center position, and the power and total power supply on the machine tool operating panel is turned off in turn;
