(1) The location environment requirements of the processing center
There must be no vibration sources near the location of the processing center. If there is a source near the processing center, the processed center should be set up around the processing center. Otherwise, it will directly affect the processing accuracy and stability of the CNC processing center, which will make the electronic components in poor contact, failure, and affect the reliability of the processing center. The location of the processing center should be far away from the source of the vibration, and the impact of direct irradiation and thermal radiation in the sunlight should be avoided, and the effects of humidity and air flow should be avoided.
(2) Temperature conditions requirements
Excessive temperature and humidity of the processing center will causeThe life of the control system decreases and leads to an increase in failure. The increase in temperature and humidity leads to an increase in dust in the integrated circuit board and cause short circuit. The environmental temperature of the processing center is less than 30 shot, and the relative temperature is less than 80%. Generally speaking, the inside of the CNC electronics box is equipped with row or cold fans to keep the electronic component, especially the central processor's working temperature is constant or the temperature difference changes very little.
(3) Power requirements
After the customer purchased the processing center machine, the general number control processing center was installed in the client processing production workshop. The customer's production workshop has a great environmental temperature and a large number of electromechanical equipment, resulting in a large fluctuation of the power grid. Therefore strict control. The power supply voltage fluctuations must be within the allowable range of machining centers and remain relatively stable. Otherwise it will affect the normal work of the CNC system of the processing center.
(4) Using requirements in accordance with the requirements of the instructions
After the three conditions of the CNC Machining Center are met, the operator of the processing center does not allow the parameters set by the manufacturing plant in the control system when using the processing center. The setting of these processing center parameters is directly related to the dynamic characteristics of the components of the processing center. When using the processing center, the operator can only be adjusted according to the actual situation of the machining center's gap compensation parameter.
