Firstly, the aluminum profile material itself is deformed, as thicker aluminum profiles are prone to deformation during the extrusion process. Scratches may occur when the material is automatically fed onto the equipment countertop during the aluminum profile cutting machine. The solution is to install a layer of 5mm epoxy resin board on the front and rear countertops of the aluminum profile cutting machine. During installation, lock it onto the equipment countertop by punching and sinking holes, and ensure that the installation height is consistent, The position of the sawing table is paved with a whole board, and the sawing seam position can be slotted with an old saw blade after installation. This method can solve the problem of scratches on the surface of aluminum profile cutting machine materials, but it is necessary to regularly replace the epoxy resin board with a new one, otherwise the board will easily wear out and affect the cutting effect after being used for a long time.
Secondly, the material rack of the aluminum profile cutting machine equipment is not adjusted horizontally with the main machine. Sometimes, the feeding rack is not adjusted horizontally. When the tail is higher than the position of the head main machine, the sawed material tail is higher and the head is lower, forming an inclined state. During the automatic feeding process, when the head is sent to the saw seam position, it is easy to scratch the side of the saw seam discharge. Only by adjusting the level of the material rack can this problem be avoided.
