Precautions for CNC lathe processing:
1. CNC lathe processing must be rigorously determined whether the tools are consistent with the program.
2. Determine the length of the knife when the knife is applied and whether the knife blade used is suitable.
3. Strictly prohibit the starting door in the operation of the machine to prevent darts or flying.
4. In the process of processing the CNC lathe, if you find that the operator of the knife, the operator must park immediately, such as pressing the "Emergency Term" button or the "reset switch" button or adjusting the "sword speed" to zero.
5. Each time in the same workpiece, you need to ensure that in the same area to ensure the accuracy of the CNC lathe processing center operation standard when the knife is connected.
6. If the processing capacity of the CNC lathe has too much processing capacity, you need to apply "single -segment" or "suspend" the value of X, Y, and Z after clearing the values. "Let it operate automatically.
7. The operator cannot leave the machine tool or check the operation of the machine during autonomous operation. If you need to leave halfway, you must check it.
8. Clean the aluminum residue in the machine tool before the light knife oil pump to prevent aluminum residue from removing oil.
9. Blow as much as possible in the procedure process, and the oil pump in the light knife program process.
11. The operator must be handed down at work to ensure that all after -process processing can be carried out normally.
12. Before standby, make sure that the CNC knife is in the initial part, and the XYZ shaft is parked at the middle of the vertical residence, and the switch power supply and total switching power supply on the machine tool operating control panel will be turned off.
13. When encountering thunderstorms, you need to disconnect the host power immediately.
