1. Understand the structure of the ordinary lathe tool holder and then disassemble it manually, and disassemble it in the order of first outside and then inside, first easy then difficult, first down and then up.
2. First, the common lathe tool rest is disassembled for fastening, coupling, and limiting parts (jacking screws, pins, clips, bushings, etc.).
3. Before dismantling, check the direction and position of the assembly to avoid mistakes during assembly.
4. The dismantled parts should be placed in an orderly manner, so that the key slot, the nail jack, and the ball screw box should be installed.
5. Pay attention to safety. When disassembling, pay attention to prevent the box from tipping or falling. The disassembled parts should be placed inside the table to avoid falling and hitting people.
6. When disassembling the parts of the ordinary lathe tool holder, it is not allowed to smash it with a hammer. When it cannot be removed or installed, do not be hard on it, and analyze the reasons (disassemble and assemble after finding out.
7. When turning the handle to observe the transmission, do not put your hand into the transmission part to prevent crushing.
The composition of the ordinary lathe tool rest: it consists of a saddle, a horizontal slide, a turntable, a tool rest slide and a square tool rest. Function: Install the turning tool and drive it to make longitudinal, lateral and oblique feeding movements by the sliding plate.
