The Longmen Processing Center must not only complete the adjustment of the trial operation at the site before the original factory, but also the purpose of the adjustment of the CNC lathe is to test whether the processing center can be installed firmly, and whether the procedures such as transmission, control, control, etc. Spectrum. Therefore, the adjustment process of CNC lathes is particularly critical. Let's talk about the adjustment process of the Dragon Gate Processing Center below?
Under normal circumstances, Longmen Processing, Longmen Processing Center to regulate the trial operation must be carried out in the following process:
1. In the operating instructions, refuel each lubricant at the Longmen Machining Center, and pour the hydraulic oil tank into the standard hydraulic oil to connect the pneumatic valve.
2. Adjust, intend to have various test tools, such as precision standards, standard square ruler, parallel square tube, etc.
3. After the Longmen Machining Center is basically running, the geometric precision of the coarse machine tool, regulate the position of the key motion component that is disassembled and the host. Find the robot, CNC knife, swap workbench, location, etc. After this kind of work is done, you need to use fast -drying cement to irrigate the host and the ground foot screws of each attachment to reserve the holes of the foot screws in various places.
4. Movement of the operation desk of the Longmen Machining Center to the swap position, change the relative position of the tray station and the swap operation desk, exceed the automatic interchange operation of the operating table, and install the large load of the operating table to carry out multiple swaps.
5. The level of precision CNC lathes enables the geometric precision of the Dragon Gate Machining Center to accommodate the error, and selects multiple pads to support it. In the casual state, the bed body is adjusted to the level to ensure the stability of the bed adjustment.
6. Adjust the robot's position on the main axis by manual control, and use the adjustment of the heart stick. When installing a large total heavy knife handle, it is necessary to do the automatic exchange of multiple times to the spindle position multiple times to achieve real and effective without impact.
7. Power on the processing center of the Longmen processing center. Each component is powered by power supply or each component is inspected at a time, and then power supply is comprehensive. Observe whether the components have alarm and manual component observation can be normal, and whether each insurance device can work. The key links can be operated and exercised.
8. Check whether the setting parameters of the CNC system and a programmable controller PLC device conform to the prescribed data in the random data, and then test the main operating functions, security measures, and the execution of common instructions.
