Different carving materials and half -bucket requirements are different as finished knives. Generally, they are designed and produced for a certain carving method or carving material. Buy the finished knife to pay attention to its materials, strength, knife parameters, and materials suitable for sculpture. And carving method, etc. When engraving metal materials, in order to reduce the number of knives and increase the life of the tool, we recommend that you use a large angle of knife as much as possible under the condition of conditions permit. At the same time, you should also choose the appropriate parameter knife. According to experience, we believe that when processing different materials, we must choose the right tool to avoid unnecessary increased costs.
The accuracy of the knife card directly affects the quality of carving. Therefore, you must follow the steps below to install the tool installation card during operation:
1. Because there are many gaps on the stuck head, it is required to scrub the card head with gasoline or alcohol before each stroke knife is required, and check and remove the residue in the gap in the card head.
2. The coordination of the stuck head and the shaft is in contact with the axis end cone hole. The contact is not good, and the tool is not easy to install. To ensure a good contact with the cone surface, scrub the cone surface with gasoline or alcohol before the knife.
3. If you use the sculpture of the foot, clean the dust with the dust cleaner and the dust on the spindle, and then install the F knife.
