1. CNC processing process is too scattered
The reason for this problem is that they are afraid of complexity (referring to preparation time), simple programming, simplified operation processing, easy to adjust with knife processing, used to ordinary processing. As a result, product quality (position tolerance) is not easy to guarantee, and production efficiency cannot be played. Therefore, CNC processing technicians and operators should fully be familiar with CNC processing knowledge, try more, to master relevant knowledge, try to use process concentration methods for processing, and use multiple times, which will naturally reflect its advantages. After the process is concentrated, the processing time of the unit increases. We arrange the two devices face to face to achieve one -person operation of two devices, which greatly improves the efficiency and the quality is well guaranteed.
2. CNC part custom order is unreasonable
Some CNC machining operators take into account some of the problems, and the processing order arrangements are often very unreasonable. CNC processing is usually processed in accordance with the requirements of the general processing process. For example, if you are rough and then refined (sword replaced), the cutting parameters are reasonably selected, so as to improve quality and efficiency.
Be careful with G00 (G26, G27, G29) fast positioning instructions G00 instructions G00 to bring great convenience to programming and use. However, if the settings and use are improperly used, it will often cause adverse consequences such as over -adjusting, decreased accuracy, and equipment guide rail strain due to excessive speed settings. If you don't pay attention to the zero route, it is easy to generate safety accidents of workpieces and equipment. Therefore, when considering the use of G00 instructions, comprehensive consideration should be considered instead of being optional. CNC hardware production
In CNC processing, pay more attention to the search and trial operation of the program. After the program enters the control system, the operator shall use the SCH key and ↑, ↓, ←, → the mobile key for uncertain and determined retrieval, and modify the program if necessary to ensure the accuracy of the program. At the same time, before the formal implementation procedure processing, the program must be run (open the amplifier) to confirm whether the processing route is consistent with the design route.
The above are some common problems and solutions when using CNC processing equipment. Some other problems may be encountered in actual work, but as long as the technical personnel and operators of CNC processing engineering and operators are brainstorm and carefully master CNC knowledge and skills, CNC equipment can play great benefits for the enterprise.
